
AMBE-3000F™ Vocoder Chip Users Manual
Version 3.4, April, 2014
Dat
a and Configuration Packets
1 Byte 1 Byte
0x10
0x00
(anything different indicates error)
Table 52 PKT_LOWPOWER Response Field Format
PKT_CODECCFG field (varies bytes) this field contains configuration data that the ABME-3000™ will send to the codec
after it receives a PKT_CODECSTART packet.
PKT_CODECCFG Field - Packet Format
Field Identifier Control Field Data
1 Byte (R) +1 Bytes
0x38 # of regs (R) reg# regdata … reg# regdata
Table 53 PKT_CODECCFG Field Format
#of regs (R) bytes contains the number of control registers that will be programmed (where 0 < R < 10)
reg# byte is the value of the control register the following byte of data is to be used for.
regdata byte is the value that will be placed in the preceding control register number.
PKT_CODECCFG Field (default values)- Packet Example
Field
Identifier
Control Field Data
1 Byte 11 Bytes
0x38 0x05 0x01 0x41 0x02 0xA0 0x04 0x83 0x05 0xBB 0x06 0x04
Table 54 PKT_CODECCFG Field Example Data (default values shown)
PKT_CODECCFG field (1 byte total) Indicates that the AMBE-3000F™ Vocoder Chip sent a configuration packet to the
Codec.
PKT_CODECCFG Response Field - Format
Field Identifier Response Field Data
1 Byte 1 Byte
0x38
0x00
(anything different indicates error)
Table 55 PKT_CODECCFG Response Field Format
PKT_CODECSTART field (2 bytes total) this will switch the AMBE-3000F™ Vocoder Chip from packet mode to codec
mode. It also causes the Codec Reset signal to be set. Then the codec configuration words that were set using the
PKT_CODECCFG field, are sent via the I
2
C pins. After entering Codec mode the AMBE-3000F™ Vocoder Chip will output
packets containing channel data every 20ms. The channel data is obtained by encoding the speech samples received from the
selected codec interface.
PKT_CODECSTART Field - Packet Format
Field Identifier Control Field Data
1 Byte 1 Byte
0x2A See Table 57 PKT_CODECSTART Field Data
Table 56 PKT_CODECSTART Field Format
(Subject to Change) Page 67
DVSI CONFIDENTIAL PROPRIETARY
Komentarze do niniejszej Instrukcji